Tensorgrip L17 Hi-Temp contact spray adhesive, high performance, 120°C, 500 ml

TensorGrip® L17 is a high-performance contact adhesive. Suitable for bonding HPL, GRP and aluminium to a wide variety of substrates including MDF, chipboard, plywood and many other timber sheet materials and is designed for permanent bonding where immediate bond strength and high heat resistance are required.

IMO-MED Approved

Open time up to 40 mins, dries in 1-2 mins (dependant on temp & humidity).

High Temp Resistance - 120°C.

Developed For

• Aluminum
• FRL
• FRP/GRP
• Plaster Board
• Standard Laminate

Directions for use:

Make sure that surfaces are clean, dry and free from dirt.

Shake well and then spray about 10-20 cm (4” – 8”) away at a 90° angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. Spray both surfaces vertically and horizontally.

Allow 2 - 4 minutes for the adhesive to tack off then adhere surfaces and press together with adequate pressure (a roller is recommended to apply a uniform pressure to achieve maximum strength). 

Allow 24 hours for the adhesive to fully cure.

For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C-27°C (60°F-80°F). Use with adequate ventilation.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. 

For more detailed application instructions, see the product data sheet in the technical documents.