Tensorgrip F11 HP DCM Free Foam Bonding Adhesive, 22 l

Tensorgrip® F11 is a high-performance plasticiser-resistant adhesive, specially formulated to bond all commonly used substrates found within the foam and upholstery industry. The F11 will bond vinyl, rubber, leather and plastics, without causing delamination.

Open Time up to 15 mins

Advantages

• 100% resistant to delamination 
• High-temperature resistance – up to 155°C.
• Fast tack time.
• Will bond many fabrics to difficult substrates.
• Single-sided bonding.
• Liquid Resistant
• Low V.O.C.

Developed For

• Carpet
• Fabric
• Foam
• Rubber
• Synthetic Leather
• Properties

Directions for use:

Make sure that surfaces are clean, dry and free from dirt. Spray about 10-20 cm (4” – 8”) away at a 90° angle to the surface, applying a uniform,

even coat of adhesive to obtain 80% to 100% coverage of the surface. Spray both surfaces to be bonded, onesurface vertically and the other surface horizontally.

Allow 4 - 6 minutes for the adhesive to tack off then adhere surfaces and press together with adequate pressure (a roller is recommended to apply a uniform pressure to achieve maximum strength). 

Allow 24 hours for the adhesive to fully cure.

For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C-27°C (60°F-80°F). Use with adequate ventilation.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. 

For more detailed application instructions, see the product data sheet in the technical documents.