Tensorgrip L31 Mist/Pebble Fine Spray Adhesive, 22 l

Tensorgrip® L31 is suitable for bonding HPL and paperback veneers to a variety of substrates including MDF, chipboard, plywood and many other timber sheet materials. It is designed for permanent bonding of materials where immediate bond strength and high heat resistance are required. The L31 can also be used for bonding sheet metals where surface preparation is very important; the surface must be degreased and lightly abraded with fine abrasive or non-woven material.

Open Time Up to 10 mins

Advantages

• Ultra-Flat Glue Line.
• Suitable for Post-Forming.
• High Performance Neoprene-based Resin.
• High Solids.

Developed For

• High Gloss/Def Laminate
• Post-Forming
• Standard Laminate
• Veneers

Directions for use:

Make sure that surfaces are clean, dry and free from dirt. Shake well and then spray about 10-20 cm (4” – 8”) away at a 90° angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. Spray both surfaces one vertically and the other horizontally.

Allow the adhesive to tack off then adhere surfaces and press together with adequate pressure (a roller is recommended to apply a uniform pressure to achieve maximum strength). 

Allow 24 hours for the adhesive to fully cure.

For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C-27°C (60°F-80°F). Use with adequate ventilation.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. 

For more detailed application instructions, see the product data sheet in the technical documents.