Tensorgrip L22 DCM Free Fine Web Spray Adhesive, 500 ml

Tensorgrip® L22 is a fine spray adhesive for the permanent bonding of materials where immediate bond strength, water resistance and high heat resistance are required. It is suitable for bonding HPL, hard plastics, GRP, foams and fabrics to a variety of substrates including MDF, chipboard, plywood and many other timber sheet materials. The L22 can also be used for bonding sheet metals where surface preparation is very important.

Open Time Up to 30mins

Advantages

• Fast Drying;
• Low V.O.C.;
• Good Heat Resistance 115°C;
• Very High Solids;
• Non-Chlorinated Formulation;
• Great compatibility with Low surface energy materials.

Developed For

• Aluminum
• Standard Laminate
• Synthetic Leather

Directions for use:

Make sure that surfaces are clean, dry and free from dirt. Shake well and then spray about 10-20 cm (4” – 8”) away at a 90° angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. Spray both surfaces vertically and horizontally.

Allow 2 - 3 minutes for the adhesive to tack off then adhere surfaces and press together with adequate pressure 

Allow 24 hours for the adhesive to fully cure.

For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C-27°C (60°F-80°F). Use with adequate ventilation.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. 

For more detailed application instructions, see the product data sheet in the technical documents.