TensorGrip T18 high tack mist spray adhesive, 500 ml

TensorGrip® T18 is a mist spray adhesive designed for the purpose of bonging of fibrous matting. This hi-tac product with its immediate makes it the prefect product for temporary holds and fast application. TensorGrip® T18 is the perfect product for bond fibrous materials to metal and other materials with only a small amount of adhesive needed.

Open time 10 mins. Colour clear.

Advantages

• Extra Fine Mist
• Fast Flash
• Hi-Tac
• Excellent Adhesion to Fibrous Materials

Suitable for

• Aluminium
• Sheeting
• Fibreglass Infusion
• Thick Fabric
• Clear
• Thin Fabric

Application

Make sure that surfaces are clean, dry and free from dirt. Shake well then spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray only one surface to be bonded. (this product is designed to be applied to one side of the surfaces to be bonded together, However, It can be used for double sided bonding where required).

Allow 30 seconds for the adhesive to tack off until no adhesive transfers to the knuckle when touched.

Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.

If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.

For more detailed application instructions, see the product data sheet in the technical documents.